Search results
Create the page "At (command)" on this wiki! See also the search results found.
- * To update the version of nginx in the deployment, execute the following command: ...ack an object's rollout, you can use the <code>kubectl rollout undo</code> command.140 KB (19,601 words) - 06:57, 9 September 2021
- ...019. Istio is being refactored and some of the following will have changed at some point in the future.</div> * Bring up Istio's control plane (this command may need to be repeated to ensure the pilot container starts):11 KB (1,410 words) - 21:29, 16 August 2021
- *<code>chronic</code>: runs a command quietly unless it fails *<code>parallel</code>: run multiple jobs at once1 KB (183 words) - 02:42, 16 March 2020
- * Enable <code>kv-v2</code> secrets at the path internal: Success! Enabled the kv-v2 secrets engine at: internal/18 KB (2,206 words) - 21:16, 15 April 2020
- ...over computer networks against eavesdropping or need to identify the party at the other end. It is widely used by Internet servers, including the majorit [[Category:Linux Command Line Tools]]4 KB (594 words) - 23:29, 25 June 2020
- ...ng a here document. This could be in a shell file or entered interactively at a prompt. ...r value. (Note that while tabs can typically be entered in editors, at the command line they are typically entered by <code>Ctrl-V + Tab</code> instead, due t7 KB (1,241 words) - 00:46, 29 June 2020
- LPIC-1 certifies the ability to perform maintenance tasks with the command line, install and configure a computer running Linux, and be able to config ** Provide common commands to the boot loader and options to the kernel at boot time.6 KB (733 words) - 22:25, 30 April 2021
- '''dig''' (aka "Domain Information Groper") is a network administration command-line tool for querying the Domain Name System (DNS). When you pass a domain name to the dig command, by default it displays the A record (the IP address of the site that is qu17 KB (2,253 words) - 09:22, 21 September 2021
- # Boxes are configured at 101, 102 and so on [[Category:Linux Command Line Tools]]6 KB (769 words) - 21:10, 29 March 2022
- This command will walk you through creating a new Pulumi project. Press ^C at any time to quit.12 KB (1,530 words) - 19:11, 1 October 2021
- ...btain information about the kernel and to change certain kernel parameters at runtime (sysctl). * <code>/proc/PID/cmdline</code>, the command that originally started the process.10 KB (1,571 words) - 22:24, 20 January 2022